ACR Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Looking for input from anyone who may have done something similar. I put two small tabs of soft-side velcro on the inside of my M-LOK handguard to remove the rattle. It works perfectly, but I'm concerned about it melting and causing issues. I know velcro is relatively heat-resistant, but this area will definitely get hot. Anyone tried anything similar?

Automotive tire Motor vehicle Bumper Wood Automotive design
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #2 ·
Update: who am I kidding - it was definitely going to melt. I gently bent the handguard in a vice until it fit perfectly with no play. Working great now.
 
1 - 3 of 3 Posts
Top