ACR Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
31 Posts
Discussion Starter #1
Im trying to do a two tone (waiting on parts) and well I was curious has anyone taken the cheek comb off their stocks? and if so how hard was it?
 

·
Premium Member
Joined
·
505 Posts
It's a tricky one. Some heat back at the pivot joint will help a lot. Also make sure it is in the higher position then peel one side up and over with a screwdriver. The locking cam is right about where the serrations are. Go slow and good luck.

Mike
 

·
Premium Member
Joined
·
3,048 Posts
I would consider doing this if magpul/bm offered an OD green replacement seeing as how I want to go with OD green furniture

Sent from my DROID PRO using Tapatalk
 
1 - 3 of 3 Posts
Top