7.62x39, 6.8, 6.5, 7.62x51 (.308) Discussion
The following is most of the information for my conversion of my Bushmaster ACR from .223 Remington to .264 LBC-AR (aka 6.5 Grendel). If you think I...
I'm looking into getting into this caliber, but the ammo pricing seems to be rather exorbitant. Anyone know of a cheap seller/round?
I'm hoping remington will eventually make a caliber change kit for this round.
just could not wait any longer for Freedom group to provide parts so-I robbed my barrel nut and the shim and mounted and test fired my model 1 300...
I was talking to bpasky about a sbr project and he wanted me to help build him a 300 blk acr, so he sent me a complete barrel set and a noveske 10"...
Ballistic advantage has a batch available. More than one contour available. Call and ask for Janna. She was extremely polite and very helpful. Cost...
New to both the forum and the ACR so please bare with me if this has been discussed already. I am considering on purchasing a ACR at the end of the...
Machining wise everything is done. Piston rod cut and reprofiled, op rod support turned down, barrel shortened to around 11" and threaded, Bolt...
I have had a 6mm x 45 mm CAR heavy barrel laying around my bone pile of parts for some time now, assuming gas system parts become available in the...
I guess I'll kick this off since this is hopefully the primary cartridge I want an ACR in. My hopes are its a 6.5 Grendel but I dont know if Bill and...
Has anyone heard anything about when 6.8 conversion kits will be available? I live in Iowa, and want to go deer hunting with my ACR but you have to...
I just emailed Bushmaster and asked whether ACR was going to offer an option to delete the right-side safety and when other calibers would be...
I found this pic while surfing around for 6.8 info awhile back. I'm really excited about getting a 6.8 conversion for the ACR so I can do up a...
Has anyone heard any details on the 6.8 version? I assume Magpul will release a 6.8 PMAG around the same time, no? Reading other forums, the Barrett...
Some years back, shortly after 6.8mm made it's splash onto the shooting scene, I built an AR upper on a then Ko-Tonics barrel. I liked shooting 6.8....
things are looking good up to this point, here is what I have so far : a 16 inch mid gas melonited barrel as made by www.ar15performance.com , 2...
What magazine could be used if there is a 7.62x39 barrel produced by bushmaster? Will an AK mag fit? Will there be a new design?
For those that have pre ordered they will be in the mail shortly(mostly because I have to work today). I test shot them last night and am doing my...
Loking to convert over to the above mentioned cal,cant find a bbl.Any one out there know where i can find a bbl?
Has anyone out there had any exposure to the 7.62x40WT? (Link below) http://www.wilsoncombat.com/762x40wt.htm Seems to be the same concept as...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules
